Simplify3D User Forum

3Dprintergear

You don't have to make it so complicated. Both the Zortrax and UP/Afinia printers use a raft on top of support before the object and both of these printers are class leaders in this department. Zortrax having copied the UP. Works fine on all sorts of irregular shaped prints. Leave support the way it...

3Dprintergear

Thanks Richwebb and Dennisjm. I found the issue. It was in the firmware configuration. Under X3G tab, replicator2 was selected, which of course doesn't have a heated bed! Once I selected Replicator 1 Dual the bed starting heating as before. I think that because I am using different printers with dif...

3Dprintergear

Hi All, I'm having some problems getting my bed to heat up on the creator pro. I have tried selecting FFF creator single, right or dual with no change. Can someone please clarify a few things. 1. In the preferences it shows T0 for both hot end and bed. Shouldn't this be T2 ( ext1=0, ext2=1, bed=2) ?...

3Dprintergear

I'm using repetier, which I know isn't supported. But I just want to save to SD and print from there.

Just need a few numbers to start with. What I tried didn't work and the printer just paused about 4 seconds into the print. Obviously I'm doing something wrong...

3Dprintergear

Hi all, my first post here.

I have a delta style printer and being a bit of a novice I was hoping someone could share a configuration file for a delta printer, just to get me started.

Thankyou

Regards
Jamie

Search found 5 matches

Re: Tips for surface finish on top of support?

Re: Flashforge Creator Pro bed not heating

Flashforge Creator Pro bed not heating

Re: Delta / rostock setup starting point ?

Delta / rostock setup starting point ?