Search found 4 matches
- Mon Mar 24, 2014 11:11 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Automatic support generation isn't wide enough
- Replies: 7
- Views: 7179
- Jump to post
Re: Automatic support generation isn't wide enough
It helped, but didn't alleviate it completely (see image below). I changed it to 1mm and the support disappeared all together...at 1.5 it's better, but still going to have sloppy bottom. There really needs to be a setting that allows for support to extend beyond the edge. I'm just surprised this doe...
- Mon Mar 24, 2014 12:32 am
- Forum: Troubleshooting and Bug Reports
- Topic: Automatic support generation isn't wide enough
- Replies: 7
- Views: 7179
- Jump to post
Automatic support generation isn't wide enough
Hey all, whenever I use automatic support generation on something that is a straight overhang it doesn't generate enough support (see image). Anyway to correct this with settings?
-Lon
-Lon
- Sat Jan 11, 2014 9:12 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Top and bottom fill
- Replies: 2
- Views: 2746
- Jump to post
Top and bottom fill
Hey all, for a while now I've given up on using Simplify3D (even though its $$). It just doesn't fill the top and bottom layers very well. When printing the first layer it just looks like it's expecting the extrusion to be _much_ wider than it is (same with some top spots). Other than that, it's a d...
- Tue Jul 16, 2013 5:54 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Trouble with raft
- Replies: 1
- Views: 2497
- Jump to post
Trouble with raft
Hey all, I was hoping the raft in Creator would be better than it was in the open-source space, but I think I'm out of luck or maybe am doing something wrong. The raft will NOT release from the part...it is fused. I've tried all types of settings...changing the extrude temps to very low all the way ...
