Search found 5 matches
- Thu Oct 03, 2013 7:34 pm
- Forum: General Discussion and Tips
- Topic: Next release?
- Replies: 1
- Views: 2221
- Jump to post
Next release?
I was wondering when the next release might be coming out?
- Tue Sep 17, 2013 4:52 pm
- Forum: General Discussion and Tips
- Topic: Blobs and gaps? Cost and retract?
- Replies: 2
- Views: 3840
- Jump to post
Re: Blobs and gaps? Cost and retract?
I have this issue as well
would be nice to see if someone has a resolution
would be nice to see if someone has a resolution
- Sat Aug 10, 2013 2:08 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Can't connect to Solidoodle 3
- Replies: 4
- Views: 5560
- Jump to post
Re: Can't connect to Solidoodle 3
So that got it to connect!!
but now when it runs it goes so slow?
is there away to configure the steps per mm in this software like in repetier host?
but now when it runs it goes so slow?
is there away to configure the steps per mm in this software like in repetier host?
- Thu Aug 08, 2013 12:03 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Can't connect to Solidoodle 3
- Replies: 4
- Views: 5560
- Jump to post
Re: Can't connect to Solidoodle 3
I'll give that a try and post my findings
thanks for the advice hopefully it will work
thanks for the advice hopefully it will work
- Wed Aug 07, 2013 10:18 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Can't connect to Solidoodle 3
- Replies: 4
- Views: 5560
- Jump to post
Can't connect to Solidoodle 3
I purchased Simplify 3d and I haven't been able to connect with my solidoodle 3. I've used the same settings on Repetier-Host which works fine there but not on Simplify 3d. Here's what I've tried matching the buad settings resting the printer board controller made sure no software was communicating ...
