Search found 3 matches

Go to advanced search

by Shinto
Fri Aug 30, 2013 5:27 pm
Forum: General Discussion and Tips
Topic: Feature request
Replies: 17
Views: 5381

Re: Feature request

Does setting that separation to 0 actually fix the warping on abs at times? I keep running into warping on both pla and abs. I have a problem with warping on the edges of overhangs. Supports keep this edges "binded" to a heated bed so they are not curling so much. But when there is a layer separati...
by Shinto
Mon Aug 26, 2013 4:09 pm
Forum: General Discussion and Tips
Topic: Feature request
Replies: 17
Views: 5381

Re: Feature request

Yes, I know about manual support and I'm mostly using 0.7, 1, 1 settings for layer separation, but sometimes (i.e. to prevent ABS warping) I need to set layer separation to 0. And sometimes supports are melted with main material within one layer. Also (but I need some free time to check this more ca...
by Shinto
Mon Aug 19, 2013 5:28 am
Forum: General Discussion and Tips
Topic: Feature request
Replies: 17
Views: 5381

Feature request

Hello, before s3d Creator I was using Slic3r and I miss some features from it. Like my favorite honeycomb infill and supports with lower extrusion multiplier. Supports made with Creator are very hard to break sometimes, so it will be very cool if I can change an extrusion multiplier to make supports...

Go to advanced search