Search found 4 matches

Go to advanced search

by guidozelf
Fri Dec 06, 2013 9:14 am
Forum: General Discussion and Tips
Topic: Found 2.0.0 in the downloads last night
Replies: 21
Views: 4925

Re: Found 2.0.0 in the downloads last night

I felt very much let down after I was "forced" to buy the previous version, without an option to try it out - since it didn't play well with my Rep2. Just downloaded this new version, and it looks like a big (really big) improvement: immediately able to print, with heated bed and without much tinker...
by guidozelf
Fri Sep 13, 2013 12:44 pm
Forum: Troubleshooting and Bug Reports
Topic: Need to add HBP to Replicator 2
Replies: 5
Views: 4759

Re: Need to add HBP to Replicator 2

Thanks for your really extensive answer! learned a few things, which is always good. I tried to do exactly what you suggested earlier, but this leads to no heating at all, i.e. no bed and no extruder. Clayton mailed this to me: You need to add the HBP into the Creator software settings since it auto...
by guidozelf
Sun Sep 08, 2013 4:45 am
Forum: Troubleshooting and Bug Reports
Topic: Need to add HBP to Replicator 2
Replies: 5
Views: 4759

Re: Need to add HBP to Replicator 2

Thanks, yes I'm on the GPX forum as well with this ;-) The temp override only works if there's a temp set in the first place - something I can't get working yet. Deducing from the Rep2X was what Clayton suggested in an email to me, but I can't see how to do that: the G-Code start doesn't include the...
by guidozelf
Sat Sep 07, 2013 8:26 am
Forum: Troubleshooting and Bug Reports
Topic: Need to add HBP to Replicator 2
Replies: 5
Views: 4759

Need to add HBP to Replicator 2

I'm new to S3d and find it not so Simple ;-) With my Replicator 2 I've been using Makerware, RepG40-R22-Sailfish and Kissslicer with GPX. I've upgraded my Rep2 with a HBP (bottleworks), ALU arms, ALU X carriage and ALU extruder 3in1 and of course use Sailfish firmware. In all slicers mentioned above...

Go to advanced search