Hi,
Just wondering if it is possible to connect to your printer (Makergear m2 in this case) through Simplify3d when it is plugged into an airport extreme's usb port? Guessing it is a bit of a long shot but would be super handy if it worked!
Appreciate any help
Cheers!
Search found 4 matches
- Sat Feb 28, 2015 9:17 pm
- Forum: General Discussion and Tips
- Topic: Use Airport Extreme USB Port
- Replies: 3
- Views: 2358
- Jump to post
- Wed May 07, 2014 5:42 am
- Forum: Troubleshooting and Bug Reports
- Topic: 2.1.0 Crashes when importing model, Mac Mavericks OS
- Replies: 8
- Views: 6888
- Jump to post
Re: 2.1.0 Crashes when importing model, Mac Mavericks OS
I have this same problem (both of them) with 2.0 and OSX Mavericks get the std::bad_alloc when importing some models. Upgraded to 2.1 and now it just crashes when I open any model. Pretty Disappointed. Seems since 1.1.5 Both 2.01 and 2.1 have had some really annoying Bugs. Suggestions as it is compl...
- Wed Dec 25, 2013 9:48 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Bed Leveling not working Properly in 2.01
- Replies: 7
- Views: 6670
- Jump to post
Bed Leveling not working Properly in 2.01
Hi, I have installed 2.01 and everything seems to be going ok except that the bed leveling wizard is playing up. When you click begin leveling it zeros on the end stops then goes to the corner and touches the first point correctly , but when you push next it goes up and moves to the next x-y coordin...
- Sun Sep 08, 2013 8:08 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Creator on Raspberry pi
- Replies: 2
- Views: 4942
- Jump to post
Creator on Raspberry pi
Hi, Just wondering if anyone has successfully installed creator on Raspian on the Raspberry pi? I Have tried install from the icon and just get nothing and if I do the “sudo ./S3DCreator*installer.run” I get: Syntax error "(" unexpected. (sorry not on my pi at this point, but think it refe...
