Adrian,
under the user where you installed S3D you will find:
./Library/Preferences/com.simplify3d.Creator.plist

I am not sure if you find anything you look for.
There is a nice OSX utility Find Any File
On your own risk. You need to be SU
Hope this helps. Jakob

Unfortunately the X3G button is not mentioned in this great document. BTW: under this TAB I see the comment "This section is For MakerBot Printers Only!" I have the suspicion by changing the Profile to other than Replicator 2 (default config) it is influencing the Firmware of a attached Marlin Contr...

I work with 0.1 Z offset using a glas plate and spraying hairspray on it.
The bed is heated to 100C.
This works great for ABS with layer thickness down to 0.15.
Plus a speed reduction of min 50%

I did not get the impression that CatDog was questioning the quality of the Software. As I read it he pointed to the missing documentation. We all have paid for this Software of wich I think works pretty well and produces good results. Is is to much if some user ask for some documentation to shorten...

Thank you, great what you have done. This shortens the learning time a lot.
Kobi

Hi, specially when you work with ABS the first Layer is more sensitive to adhesion printing with small layer hight. To eliminate this issue I use Hairspray. Spraying it on the PET Foil. Jakob

I don't experience this kind of issues on OSX 10.9.2

Hi, to determine the optimal Z hight I am looking to give the Z axis a small Z offset value. As far as I can see all the Parameters i can influence in S3D require a new "Prepare" action" which changes the Z hight. ( I have tried in menu model setting and Gcode/Gcode offset.) Having this functionalit...

Jim,
Its the first layer only. Interestingly If I put a raft around. The Raft extrusion is right but the actual 3D piece is under extruded.
Jakob

Hi.
Supagoat, it looks to me that I struggle with the same issue. (under-extruding)
Q: ti which settings in the Layer settings do you refer?
Thanks in advance for the advice.
Jakob