Search found 4 matches
- Fri Mar 07, 2014 2:53 am
- Forum: General Discussion and Tips
- Topic: Obtuse Layer Heights
- Replies: 4
- Views: 3127
- Jump to post
Obtuse Layer Heights
Why does the software use an odd layer height of .2857mm for medium and .1714 for high? I know there has to be logic to these values, I just don't understand why. I'm using a Makerbot Replicator 1 & Printrbot Jr V2.
- Mon Mar 03, 2014 7:24 pm
- Forum: Feature Requests
- Topic: [ADDED] Speed - mm/minute? Why not mm/sec?
- Replies: 75
- Views: 71356
- Jump to post
- Mon Feb 17, 2014 4:49 am
- Forum: General Discussion and Tips
- Topic: Top/Bottom Layer vs Infill direction
- Replies: 2
- Views: 2142
- Jump to post
Re: Top/Bottom Layer vs Infill direction
Thats not what I was asking. I am asking for a way to have the top and bottom layer direction be different than the infill direction. If you have -45 / 45 in it, which is the default value, both the top and bottom layers and the infill are at -45/45. On MakerWare, top and bottom layer direction are ...
- Thu Feb 06, 2014 5:18 am
- Forum: General Discussion and Tips
- Topic: Top/Bottom Layer vs Infill direction
- Replies: 2
- Views: 2142
- Jump to post
Top/Bottom Layer vs Infill direction
New owner, love the product. I'm struggling figuring out how to make the shells go a different orientation than infill. Since we have to use linear infill, I prefer them to be 90 degrees offset from the shell directions. The infill and top and bottom layers seem to obey the infill directions defined...
