Search found 3 matches
- Wed Mar 12, 2014 6:42 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Gaps in solid infill if layer heigth <= 0.15mm
- Replies: 1
- Views: 2087
- Jump to post
Gaps in solid infill if layer heigth <= 0.15mm
Hey everyone, every time I print something with a layer height <= 0.15mm I got sparse infill instead of solid infill (see picture). Also if I set the extrusion width manually below the automatic value (0.5mm instead of 0.8mm, nozzle diameter 0.4mm) there is way too little filament extruded. The step...
- Tue Mar 11, 2014 1:41 pm
- Forum: Feature Requests
- Topic: Feature Request: Directly view Gcode file from Simplify3D
- Replies: 2
- Views: 5358
- Jump to post
Feature Request: Directly view Gcode file from Simplify3D
Hey everyone,
it would be nice, to be able to access and vew the generated Gcode file directly from the Simplify3D software.
I'm sorry if this option already exists, but I haven't found it anywhere.
Cheers
it would be nice, to be able to access and vew the generated Gcode file directly from the Simplify3D software.
I'm sorry if this option already exists, but I haven't found it anywhere.
Cheers
- Tue Mar 11, 2014 1:38 pm
- Forum: General Discussion and Tips
- Topic: Feature Request: No generated GCode before scripted start
- Replies: 1
- Views: 1875
- Jump to post
Feature Request: No generated GCode before scripted start
Hey everyone, I realized, that Simplify3D generates Gcode before the scripted start Gcode (i.e. Heating and Cooling commands). This is really annoying, because it makes my autonomous start routine without any oozing impossible. Is there a way, to put these generated Gcode lines after the start Gcode...
