Search found 5 matches
- Tue Jun 17, 2014 6:31 am
- Forum: General Discussion and Tips
- Topic: Z not correct
- Replies: 2
- Views: 1796
- Jump to post
Z not correct
I have been printing with S3D for about a month and life was good. Now all of a sudden the Z is not correct. The parts get to tall. Sometimes by a lot sometimes by a little. doesn't seem consistent. I have been resorting to slice in Cura then print with S3E and everything works fine that way. I have...
- Fri Jun 06, 2014 11:37 pm
- Forum: Troubleshooting and Bug Reports
- Topic: framing error detected by hardware
- Replies: 3
- Views: 3571
- Jump to post
Re: framing error detected by hardware
FIXED.
This was a simple error on my part by not checking the baud rate. When i selected the correct baud rate everything works fine.
This was a simple error on my part by not checking the baud rate. When i selected the correct baud rate everything works fine.
- Thu Jun 05, 2014 3:15 am
- Forum: Troubleshooting and Bug Reports
- Topic: framing error detected by hardware
- Replies: 3
- Views: 3571
- Jump to post
framing error detected by hardware
What does this mean " framing error detected by hardware "
Using Ramps 1.4.
I can connect with Repeiter and operate this printer but S3D gives this error. Anybody seen this before?
Using Ramps 1.4.
I can connect with Repeiter and operate this printer but S3D gives this error. Anybody seen this before?
- Sun Apr 27, 2014 3:49 am
- Forum: General Discussion and Tips
- Topic: Large file
- Replies: 2
- Views: 1881
- Jump to post
Re: Large file
That sounds like a great work around. I will see if i can make a boundary box in DesignSpark Mechanical, as that is my preferred CAD ware.
- Thu Apr 24, 2014 4:56 am
- Forum: General Discussion and Tips
- Topic: Large file
- Replies: 2
- Views: 1881
- Jump to post
Large file
How to view a large file that is outside of the printer area. The file is 5421KB and cannot load because of the size. It ends up locking up my PC every time.
