Simplify3D User Forum

ta1dr

Hi All I used ver.2.2 S3D but I have problem about the support...when actived support or manuel define all ok but prepare to print click give error....could you have any idea ? BTW I tried reset my all setting but no any change.. my system XP an Turkish error mean " 0x...... not reading" h...

ta1dr

Thanks Jimc

I reduce printing speed (old 3600mm/min new:2400mm/min) and 4 bottom, 6 top layers, extruder multiplier=1 also off random infil I tried like this results fine ...

thanks again...

ta1dr

Hello All
My new printer ( my design) like a cube and I used bowden extruder but I didnt normal quality print
I need to your comment ;

my_3d.fff: my settings....; (8.94 KiB) Downloaded 382 times

ta1dr

Hello All I am S3D and Kisslicer user. I tried small part two slicer There are some differences I can not decide which was best to... http://www.ta1dr.com/slicer/r1.jpg http://www.ta1dr.com/slicer/r2.jpg http://www.ta1dr.com/slicer/r3.jpg and s3d profil files http://www.ta1dr.com/slicer/40mm_sn_cran...

ta1dr

thanks for answer, I do it

ahmet

ta1dr

how can I do update? I tried like this help--> check uptade and give no any update also my software 2.1.0

ta1dr

You can double click on the item and through the window that pops up (you can move it to the side if you want to see the model on the build platform) try adjusting either the X or Y rotation by 180 degrees and you should get a live preview of the rotational effect. After "drop the table" ;)

ta1dr

thanks Arno very usefull but I have bat day start last week (friday) also still continues My electronics arduino mega+ramps and I printed SD card (not usb connection) also I used ‘Surge protection - connector strip" my printer stops at random times I changed SD card I changed power supply I din...

ta1dr

thanks Laird;
I change Z axis step settings I used microstep (1/16) changed 1/2 step and update firmware,

http://calculator.josefprusa.cz/#ExtrusionSF40

my problem reduced Maybe if I change Z axis screw ( threaded shaft) , reduce more...

ta1dr

thanks all
yes you right I 've found the z-axis vibration and wobbly too. I make some construction for prusa frame and M10 threaded shaft but not success I thing I must to change M5 (Z -axis threaded shaft) and maybe other parts

regards
Ahmet

Search found 12 matches

support problem

Re: bowden extruder and print

bowden extruder and print

S3D and Kisslicer compare

Re: NEW version today, or yesterday...2.1.1

Re: NEW version today, or yesterday...2.1.1

Re: new here. need to rotate

Re: how to restart the print after a crash

Re: layer problem

Re: layer problem