There are issues with W 10 and printers, here's a video from youtube. https://www.youtube.com/watch?v=8O7kFbVhIJk
Sorry didn't realize I was on page 2, saw someone else posted the video. Yea I have same issue. Its making me mad
Search found 6 matches
- Thu Aug 06, 2015 1:23 am
- Forum: Troubleshooting and Bug Reports
- Topic: Having issues after Win10 upgrade
- Replies: 13
- Views: 9512
- Jump to post
- Sun Jul 19, 2015 9:40 am
- Forum: Troubleshooting and Bug Reports
- Topic: WARNING: CRC mismatch detected
- Replies: 20
- Views: 31446
- Jump to post
Re: WARNING: CRC mismatch detected
OK yea this is weird I have been getting CRC mismatch with my FlashForge as well. It does however connect and work just fine. I may have been getting them all along I only noticed after I clicked off verbose communication. I am using sailfish couldn't say what version at the moment. I have not upgra...
- Mon Jun 09, 2014 1:02 am
- Forum: General Discussion and Tips
- Topic: Kossel Mini?
- Replies: 3
- Views: 5812
- Jump to post
Re: Kossel Mini?
You know what it was freaking easy! I love this software. I used pronterface etc to set it all up and run tests, I seemed to have issues with sending gcode, but it was my issue apparently. Set my firmware to match, RepRap, I am using Marlin. Under Options, I just selected Delta Robot. Set my build v...
- Fri Jun 06, 2014 11:40 am
- Forum: General Discussion and Tips
- Topic: Kossel Mini?
- Replies: 3
- Views: 5812
- Jump to post
Kossel Mini?
I just recieved a Kossel Mini kit and was wondering what would be a good start point for using S3D with it? I see it has a delta configuration and was wondering how anyone else did getting this working. I will of course report back on any issues etc I have.
- Sat May 10, 2014 11:44 am
- Forum: Troubleshooting and Bug Reports
- Topic: No left extruder
- Replies: 5
- Views: 4240
- Jump to post
Re: No left extruder
I am a boob at times, If you write out the object to disk it will give you the GCode if you want to read it. So there's that. If you write out the object to a flashcard it will print from both extruders. It just will not over usb. very weird. But I have made a number of prints from the left includin...
- Tue May 06, 2014 11:25 pm
- Forum: Troubleshooting and Bug Reports
- Topic: No left extruder
- Replies: 5
- Views: 4240
- Jump to post
No left extruder
I have a Flashforge and cannot get the left extruder to work for the life of me. I have tried changing the Gcode etc. It appears I am not the only one. It starts, preheats etc, then when it it ready to print it just stops and sits there with either 8% or 0% showing. From what I understand (I just pu...
