Search found 2 matches
- Fri May 16, 2014 10:14 am
- Forum: General Discussion and Tips
- Topic: Qestion about restarting a print job
- Replies: 1
- Views: 1069
- Jump to post
Re: Qestion about restarting a print job
Well, I figured it out. Not too difficult really. I removed the partially finished piece and measured the height with digital calipers. I then double clicked on the model to bring up the settings panel and set the Z offset in the negative direction using the height I obtained from the calipers. Hit ...
- Thu May 15, 2014 6:38 am
- Forum: General Discussion and Tips
- Topic: Qestion about restarting a print job
- Replies: 1
- Views: 1069
- Jump to post
Qestion about restarting a print job
Hi, I'm fairly new to 3D printing and have been using Simplify3D for a while with excellent results. Last night I started a print job that would run overnight and complete this morning. All was running smoothly and I went to bed. Unfortunately sometime during the night my system decided to restart. ...
