Search found 3 matches
- Sun Jun 07, 2015 2:07 pm
- Forum: General Discussion and Tips
- Topic: TAZ 3 Dual Extruder + Simplify3d: stuck on "Bed heating."
- Replies: 1
- Views: 1100
- Jump to post
TAZ 3 Dual Extruder + Simplify3d: stuck on "Bed heating."
After installing the Dual Extruder Tool Head on my TAZ3, gcode generated from Simplyfy3D doesn't work. It just sits on "bed heating." The bed temp is set for 90. The temp bounces between 90 and 89. Gcode from slic3r works, because it doesn't seem to wait for the temp. If I know enough abou...
- Sun May 25, 2014 6:17 pm
- Forum: General Discussion and Tips
- Topic: Start Printing at height ....
- Replies: 15
- Views: 28886
- Jump to post
Re: Start Printing at height ....
Thanks. I'm doing the second layer as 3.1 mm.
- Mon May 19, 2014 12:52 am
- Forum: General Discussion and Tips
- Topic: Start Printing at height ....
- Replies: 15
- Views: 28886
- Jump to post
Re: Start Printing at height ....
Thanks JoeJ! That's the answer I needed too. I'm trying to print an object in two colors, so I made a job that stopped at 3 mm, then a second job that starts a 3mm. I changed spools in between. There was a bit of a collision starting the second job. Forgive this noob question, but could you explain ...
