Search found 3 matches
- Mon Feb 01, 2021 12:37 pm
- Forum: Troubleshooting and Bug Reports
- Topic: 4.1 Hangs During Install
- Replies: 10
- Views: 5911
- Jump to post
Re: 4.1 Hangs During Install
Silly question, have you tried removing one monitor for the installation and then going back to two once it's installed?
- Mon Oct 26, 2020 2:07 pm
- Forum: Troubleshooting and Bug Reports
- Topic: BUG: Cooling M106 occurs before starting scripts
- Replies: 6
- Views: 4599
- Jump to post
Re: BUG: Cooling M106 occurs before starting scripts
Resurrecting an old thread with some further info. I have a dual extruder printer, T0 and T1 change the Tool but this is setup in the start up scripts, so... If the system powers up, T0 is normally chosen. Simplify creates it's gcode but the code generated is G90 M83 M106 S255 ; Startup script..... ...
- Mon Dec 14, 2015 6:34 am
- Forum: General Discussion and Tips
- Topic: Motor problems
- Replies: 3
- Views: 2056
- Jump to post
Re: Motor problems
Sorry to hear about your issues, there are quite a number of possibilities for the issues and to assist a bit of further information would help. (1) How did the PSU fail ie was there over voltage (+12V or +24) ? (2) I'm guessing you changed out all of the stepper motor drivers due to the above - did...
