Does anyone have any experience with following issue?
"Is there a setting to tell the slicer a max angle to stop printing top layers?"
TIA
-Mike
Search found 4 matches
- Sun Aug 12, 2018 1:04 am
- Forum: General Discussion and Tips
- Topic: Top Layer Print Angle Setting
- Replies: 2
- Views: 1511
- Jump to post
- Tue Aug 07, 2018 3:43 am
- Forum: General Discussion and Tips
- Topic: Top Layer Print Angle Setting
- Replies: 2
- Views: 1511
- Jump to post
Top Layer Print Angle Setting
When printing single wall prints for my Radio Controlled models I often need to add top layers to open areas throughout the print. The problem is that I have walls that are angled at certain degrees where the slicer thinks it is at enough of an angle to consider it a "top" surface (see att...
- Sat Apr 04, 2015 11:14 pm
- Forum: Troubleshooting and Bug Reports
- Topic: How to change initial starting purge (nozzle wipe?)
- Replies: 13
- Views: 30850
- Jump to post
Re: How to change initial starting purge (nozzle wipe?)
For dual extrusion priming you need to call the tool command, with T0 being your first extruder and T1 being the second extruder. Below are examples that we use in the Starting G-Code Script for our dual extruder machines. T1 ;Switch to the 2nd extruder G92 E0 ;zero the extruded length G1 F200 E15 ;...
- Sat Dec 13, 2014 1:56 am
- Forum: Troubleshooting and Bug Reports
- Topic: Memory Leak
- Replies: 17
- Views: 12505
- Jump to post
Re: Memory Leak
Running 2.2, one of the features I tested first was the "Dense Layer Support". Not knowing this was an issue I was getting crashes when I clicked the "Prepare to Print", then having to restart the program. Went back over my steps and found this setting set to greater than 0 prove...
