Simplify3D User Forum

Brit

I have contacted support for a week on my copy crashing with the error "simplify 3d failed to activate the software. the software will now exit". They said that there were problems, but they failed after several back-and-forth emails to come up with a solution. I want a refund and to retur...

Brit

I placed a report last week after upgrading to version 5 in the middle of last week that version 5 will not open on my laptop, after trying everything, wasting many hours reinstalling many times. The error: "simplify 3d failed to activate the software. the software will now exit" pops up t...

Brit

I did receive advice from 3D simplify support " We have seen very few reports of this error message, so I want to confirm if the problem is only specific to this one computer." I guess I'm one of the lucky ones... I sent them my computer specs (a high-end Asus gaming laptop). I'd try the i...

Brit

I just upgraded to 5.01, but I could not install it. At first, it said that my password was incorrect (even though I have it stored in Dashlane). Then it wouldn't allow me to try again and instead came up with the warning "simplify 3d failed to activate the software. the software will now exit&...

Brit

I just upgraded to 5.01, but I could not install it. At first, it said that my password was incorrect (even though I have it stored in Dashlane). Then it wouldn't allow me to try again and instead came up with the warning "simplify 3d failed to activate the software. the software will now exit&...

Brit

My "Print from SD card" suddenly no longer works in Simplify 3D on the machine control panel. Nothing appears when clicking on that control. I have tried to print with the SD card on both of my Makergear M2 machines (ruling out a single printer board). I have tried several SD cards. and la...

Brit

Sorry...where are the 'preferences'? Also, this will not help if the program will not launch, since I probably can't get to the preferences when it is closed.

Brit

It is having this problem on one machine. The other is OK, but then I rarely use it since it a desktop far from the printers. This problem happens about once a week. That said, all my other software (including lots of 3D software) works fine on this machine. My video and sound driver (and all driver...

Brit

I have contacted the technical support multiple times for my software that is crashing all the time when launching the software. They always tell me to delete my registry settings for Simplify3d. That works but it is becoming tedious (an one loses all profiles unless saved). There must be an easier ...

Brit

Hello, I am still migrating form Scli3r and Cura to Simplify3D. How do I create a grid cross hatched support system in Simplify to create stronger supports? Also I used 5% infills in my large prints in this other software. When I use 5% in simplify3D, it produces a very thin spongy infill which is O...

Search found 13 matches

Re: v5.0.1 Crashes Immediately

[FIXED] Version 5 continues to not work on some machines!

Re: Simplify 3d failed to activate the software. the software will now exit

Simplify 3d failed to activate the software. the software will now exit

Re: My "Print from SD card" no longer works in Simplify 3D

My "Print from SD card" no longer works in Simplify 3D

Re: Crashing all the time when launching the software.

Re: Crashing all the time when launching the software.

Crashing all the time when launching the software.

support in a grid and infill