Search found 4 matches

Go to advanced search

by w0nk1
Sun Jul 20, 2014 8:49 am
Forum: General Discussion and Tips
Topic: Slicing rough top layer at some points?
Replies: 7
Views: 1129

Re: Slicing rough top layer at some points?

w0nk1, You might use a second process, starting near the top, with a smaller layer thickness. Let's say you run most of the part at 0.2 mm layer thickness. Apply a second process, starting a mm or so from the top with an 0.1 mm layer thickness. Like using the thin Legos where the curvature dictates...
by w0nk1
Sat Jul 19, 2014 12:49 pm
Forum: General Discussion and Tips
Topic: Slicing rough top layer at some points?
Replies: 7
Views: 1129

Re: Slicing rough top layer at some points?

I think if you posted a picture of that same area after making that change, you would see that it most definitely makes a difference. However, you weren't very clear in your original question. If you're asking about the fact that the layers seem to be offset more and more from the layer below it as...
by w0nk1
Fri Jul 18, 2014 7:58 pm
Forum: General Discussion and Tips
Topic: Slicing rough top layer at some points?
Replies: 7
Views: 1129

Re: Slicing rough top layer at some points?

JoeJ wrote:Layer tab, change External fill pattern to Concentric.
still no difference. That is the file: http://www.thingiverse.com/thing:82478

Any other ideas? =(
by w0nk1
Wed Jul 16, 2014 5:33 am
Forum: General Discussion and Tips
Topic: Slicing rough top layer at some points?
Replies: 7
Views: 1129

Slicing rough top layer at some points?

Hi there,

I'm using Simplify3D for some days and running into some issues. After slicing models I recognize some strange offsets at the top layer (view picture for details.). Anyone has an advice to fixing this issue?

cheers,
Markus

Go to advanced search