Search found 3 matches

Go to advanced search

by exhyphen
Mon Aug 04, 2014 11:22 pm
Forum: Troubleshooting and Bug Reports
Topic: Incorrect hole sizes
Replies: 52
Views: 26714

Re: Incorrect hole sizes

My inside dimensions print too small by .5-.7mm as well, while the outsides are within .10mm depending on what I am trying for that print. I have been tinkering with the settings for a few days now, and confused by the results. It's as if the inside perimeters are shifted inward by one extrusion wid...
by exhyphen
Mon Aug 04, 2014 10:58 pm
Forum: Troubleshooting and Bug Reports
Topic: Dimensions of the Parts are not exact
Replies: 3
Views: 2267

Re: Dimensions of the Parts are not exact

It's very frustrating. My experience with this issue brought me to this forum looking for answers. I just printed a rectangular test part, going back to S3D's default settings for Makergear M2 / ABS after much tinkering, and found the outer dimensions are relatively spot-on (hundredths of a mm bigge...
by exhyphen
Mon Aug 04, 2014 10:46 pm
Forum: Feature Requests
Topic: Feature Request: Infill and Perimeter Bridging Overrides
Replies: 2
Views: 1264

Re: Feature Request: Infill and Perimeter Bridging Overrides

I have just run into something like this. When printing a part where bridging is needed in the middle of a rectangle (fully surrounded by supporting features), it takes the standard infill orientation instead of the shortest route, which would achieve better results.. I have also recently experience...

Go to advanced search