Search found 4 matches
- Fri Jul 17, 2015 7:40 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Preheat extruder slow to start
- Replies: 2
- Views: 1825
- Jump to post
Re: PRE HEAT EXTRUDER SLOW TO START
Thanks for the info. I will give that a try.
- Wed Jul 15, 2015 12:45 am
- Forum: Troubleshooting and Bug Reports
- Topic: Preheat extruder slow to start
- Replies: 2
- Views: 1825
- Jump to post
Preheat extruder slow to start
Is there anyway to change the setting for pre heat the Bed & Extruder? When I load a program to print, the bed starts to heat and it takes 13 minutes for the Extruder to start heating. Is there any adjustment to lower the wait time for the extruder to start heating? I am using a Makergear M2 wit...
- Sat Jul 11, 2015 4:32 am
- Forum: Troubleshooting and Bug Reports
- Topic: Cannot import a STL file
- Replies: 7
- Views: 5899
- Jump to post
Re: Cannot import a STL file
Talked to Simplify 3d yesterday and they told me that they have a little problem sometimes on Mac's. They advised me to Drag and Drop the file in. That did work for me. I am up and running again.
Thanks Simplify 3D support
Bob
Thanks Simplify 3D support
Bob
- Thu Jul 09, 2015 12:34 am
- Forum: Troubleshooting and Bug Reports
- Topic: Cannot import a STL file
- Replies: 7
- Views: 5899
- Jump to post
Cannot import a STL file
I cannot import a STL file. I get a errors message that says . CANNOT AUOT ARRANGE. LARGEST PART EXCEEDS BUILD DIMENSIONS. The part is much smaller the build surface. Plus I have printed these files before with no problems. The problem start with version 2.2.2. I upgraded to 3.0 a few days ago and i...
