Search found 4 matches
- Wed Dec 31, 2014 5:02 pm
- Forum: General Discussion and Tips
- Topic: BAD Filament on Ebay!!!!
- Replies: 3
- Views: 2666
- Jump to post
Re: BAD Filament on Ebay!!!!
I have bought a LOT of filament from that seller and never had an issue with him....Maybe they just got a bad batch?
- Mon Dec 29, 2014 12:25 pm
- Forum: General Discussion and Tips
- Topic: Print centering Question?
- Replies: 5
- Views: 3276
- Jump to post
Re: Print centering Question?
I believe this was an issue with the earlier profiles, due to the tool-head offsets of the FlashForge Dreamer. If you download version 2.2 of the software, go to Help-->Reset all settings, then reopen it and use the built-in profiles to print with the left I don't think you'll have that issue. That...
- Sun Dec 28, 2014 8:33 pm
- Forum: General Discussion and Tips
- Topic: Print centering Question?
- Replies: 5
- Views: 3276
- Jump to post
Re: Print centering Question?
I believe this was an issue with the earlier profiles, due to the tool-head offsets of the FlashForge Dreamer. If you download version 2.2 of the software, go to Help-->Reset all settings, then reopen it and use the built-in profiles to print with the left I don't think you'll have that issue. Than...
- Fri Dec 26, 2014 8:39 pm
- Forum: General Discussion and Tips
- Topic: Print centering Question?
- Replies: 5
- Views: 3276
- Jump to post
Print centering Question?
I am running a Flashforge Dreamer and when i print with the right nozzle it prints directly to the center of the bed as it should........now when i print with the left extruder it offsets the print over to the left a few inches.....Is there any way to make it start the print in the center of the bed...
