Cant find any problems, is running fine for me.

Your settings are not optimized but that is not the problem .
Perhaps you have used the Cross Section View and the Z-height was limited.

H.

Have a look to tab ADVANCED, perhaps there is set a stop.

horst.w
GER

otherwise please attache a " *.factory " - file here.
To be create with tab FILE >>> Save Factory as ...

a litle bit more precise:

the menue point Import FFF-File will accept the format of gcode- files with the extension ".gcode" as well as a .fff - files.

Horst.w

Import the GCode-Files as "FFF-" , than you can store all informations with "Save Factory-file as ... " into a own folder system.

Good luck!

horst.w
GER

... the actual version 4.1.2 seams to have a problem with the settings of the infill to be print every (1) layer. I have set (1) every layer by using 2 different angles. But it prints only one line direction for 1 layer and the 2nd angle while printing the next upper layer. I can't say when this iss...

Printing TPU is very critical ! Strongly recommended a direct extruder, once I have bought an Anet A8 for this, because my big printer with 70 cm bowden has no chance to work with it , ether TPU hard, TPU middle or TPU soft . TPU has a lot of abstruse preferences. Using normal print temperature make...

Yes, thats right, but the next problem is the printer. Printing from SD, all files names containing "Umlaute" are not listed in the display.

horst.w
GER

For print quality it is recommended to set the Layer Height not in a ratio higher than 1 : 2. Will say the maximum LH is 0.30 mm and below when the extrusion width is set to 0.60 mm. Otherwise you must print near a squared extrusion.

horst.w
GER

Never ending story and daily horror?? Same occurrence on Monday. BUT program closed regularly and shutdown the computer . Next day starting the computer (Win 10 - Upgrade from Win 7), ok, all is running except S3D. It didn't start but in the Task-Manager it was listed. Deleting of the SaveState.Fact...

Hi, on Monday I had also a similar crash (not clear why), but S3D didn't launch anymore. Restarting the computer, deleting S3D from the task manager (3 and 4 instances of S3D at the same time ) , nothing could help. Than, folowing aa advice from the forum here, I searched for the file "savedstate.fa...