Simplify3D User Forum

payala

@nsarzyns: I agree 100% with you, I think there are many easy ways to keep users in the loop. As you say, agile methodologies, which are being more and more adopted in all software development teams, were developed to address topics like this one. Keeping the customer in the development loop, gettin...

payala

OK, replying myself over here, vase mode is the solution for what I was trying to do. By enabling it, you can actually print only one perimeter, although for the whole model, so this is a solution just for my particular case for the extruder calibration.

Cheers!

payala

I also hit this issue when I was trying to fine-tune my extruder by printing a single wall cube... since it never prints a single line of filament, either 0 or 2, it is not possible to use this method.

I am just wondering how do S3D users fine-tune the extruder?

payala

Hi Doug, Your trick definitely did the job, I'm not sure how did you figure that out, but it's quite impressive. I just have one question remaining, when I expected to have a bridge, I didn't mean on the small gap, I expected the lower layer of all the horizontal bars to be done as a bridge. Am I wr...

payala

Not really, you can see in the picture what happens:

And the printed part shows that many of the bridges are not correctly joined to the two helix bodies. After all, bridges are needed for a reason.

payala

Hi All, I'm having an issue where bridges are not recognized in the print. You can see the model in the preview mode of S3D, with the coloring set to "feature type": no_bridges1.png A close-up from below of the bridged sections reveals that no bridges are detected: no_bridges2.png Neither ...

payala

+10 for G10/G11

Search found 7 matches

Re: When will there be an update??

Re: Slicer behavior for thin walled sections

Re: Slicer behavior for thin walled sections

Re: Bridges not generated

Re: Bridges not generated

[FIXED] Bridges not generated

Re: Feature request: Seperate retract/recover speed controls