Simplify3D User Forum

helmutdz

Ok dann versuche ich es mal auf Deutsch.

Ich gehe mal davon aus das du Facebook hast.

Schau mal hier nach die kömmen dir helfen.

https://www.facebook.com/groups/1685213 ... ef=browser

grüsse

Helmut

helmutdz

Read this through here, then you know how it goes.
http://forum.simplify3d.com/viewtopic.php?f=8&t=1538

Am at your disposal for further assistance to.

helmutdz

does not work

"update: stk500_recv(): programmer is not responding"
"update stk500_getsync() attempt 1 of 10: not in sync: resp=0x03"

who can read is a clear advantage.

and KEEP your finger on it until the process finish flashing.

now it is thank you

helmutdz

I've just contacted malyan and they gave me the lastest firmware ( V7.8) for those who are interested... leave me a PM. I'm testing it for now, and we will put it online when all the update procedure will be OK Hello acefx, I am also interest in the new firmaware. facing you what they have changed....

helmutdz

I am now working with S3D. but only with SDcard. I save about "Toolpaths save to disk". e.g. "print.gcode" then I open cmd run "gpx -c gpx.ini print.gcode print.x3g" copy print.x3g on sdcard. print it. will write in the closest days a manual. I just need more time for E...

helmutdz

Yesterday , i wrote to s3d support and they gave me that files to, but for now it doesn't work... the extruder doesn't go to the center and doesn't do the wait for heat up and the first "waste" extrude, instead of that it begin to print where it is... ++Added some harware mods Have you tr...

helmutdz

Hardware Mods and repairs 1. Extruder height Well yes , the first point i noticed was that both extruders were not at the same height ( ?!!? what ?!!?) Yep , the extruder height as an 0.3mm height offset, be sure to check about this because i wasn't able to calibrate the X & y offset during the...

helmutdz

Alan wrote:What has been the problems found when using the M180 with Simplify3D ?

das größte problem ist die Z axis, die bewegung ist zu gering.
bei einen externen aufruf von GPX kann ich das ändern.

helmutdz

Same here , the malyan M180 seems to be a replicator x2 clone but without the usual "compatibily" of the clone. the hardware seems to be ok but the software support is just shitty ! if anyone is interessted making a wiki with profile and tips and trick about this printer, we may combine o...

helmutdz

I myself use a clone of M180. This is of pearl 3D FreeSculpt.
Maybe I can help, yes. what is your problem.

Search found 12 matches

Re: malyan m180

Re: I can not find my printer in the list of supported print

Re: Malyan M180 3D Desktop printer ?

Re: Malyan M180 3D Desktop printer ?

Re: Malyan M180 3D Desktop printer ?

Re: Malyan M180 3D Desktop printer ?

Re: Malyan M180 3D Desktop printer ?

Re: M180 Malyan (3D FreeSculpt EX2)

Re: M180 Malyan (3D FreeSculpt EX2)

Re: Malyan M180 3D Desktop printer ?