Simplify3D User Forum

jjl

Hi JoeJ Your trick works :-) After I have tryed 3 times, I have to do it very fast before the program crashed, the program started up like after a new install. I typed in my username and password and everything looks fine Actually my screen looks different, now it shows the build platform of a Repli...

jjl

How to do that ?
S3D crash before I can communicate with the program !!!

How do I make a complete new and fresh install ??

I have tryed to uninstall S3D "completely", but the new install has the same setup as the old one, so the uninstall does not remove all files !!

/JJ

jjl

No, does not Work. I have tryed to uninstall S3D and then reinstall, but it still remember recent open files. S3D crash after a few seconds. Screen looks ok, left corner writes "succesfully xxxxxx triangles" and right corner the green Progress bar goes to the right, but after a few seconds...

jjl

Is there a way, from "out-side", to clear the Resent open file list in S3D ??

I have, by failure, tryed to open a non .stl file. This causes a Windows crash when I start S3D.

Thanks in advance

Jens

jjl

Okay. Thanks to both of you for the fast responce Maybe there is some Makerbot users here on this thread, so I have another question: Will a Replicator 2 be a (much) better printer with a E3D hotend and a Bondtech extruder ? I know there is some mechanical work to do, but I think I can handle that. ...

jjl

Is it possible to control the fanspeed on the Replicator 2 ?

If I set the fanspeed to 0, it will not run, but if I set it to 5% or anything else between 0 and 100%, it looks and sound like it run at 100% fanspeed !!

Any ideas ?

Thanks

Jens J. Larsen
Denmark

jjl

I also use the stock Rep2 firmware. Sailfish looks a bit complicated for me. I don't know, maybe there is a setup for Rep2 in Sailfish, have not checked !! To start the heatbed again, after the extruder has reach temperature, I have done this: Open FFF settings, select Temperature Select "Heate...

jjl

Thanks to both of you. That did the trick..........but there is an issue I think !!! When I start printing, the heatbed and Tool start to heat up as they should. Printer wait to heatbed has reach temperature and then wait for printertool to reach temperature. But of some reason the power to the heat...

jjl

Hardware:

Replicator 2 with ver. 7.5 firmware
Bottleworks Heated platform

Software
S3D ver. 2.2.0

My problem:
How do I get the heatbed to work with S3D ?

Heatbed works ok when I start preheat from the Replicator
I have added a "Heatbed" under the Temperature Tab (T0)

Search found 9 matches

Re: Clear "Resent open files"

Re: Clear "Resent open files"

Re: Clear "Resent open files"

Clear "Resent open files"

Re: Replicator 2 fanspeed

Replicator 2 fanspeed

Re: Replicator 2 plus Heatbed

Re: Replicator 2 plus Heatbed

Replicator 2 plus Heatbed