Simplify3D User Forum

CRNorris

Hi, I have a fairly chunky fan duct that I've added to my FlashForge Creator Pro. It was the only one I could get to print reliably enough without already having one. It sticks out so far that it can hit the door on the front of the printer. So I'd like to make it so that the build volume is shrunk ...

CRNorris

The live preview tracking feature is a long way behind what my printer is actually doing - like my printer is already on the next layer to what's shown in the preview. I'm using a Flashforge Creator Pro and I have live preview tracking at the default 5 second update interval. Is there anything I can...

CRNorris

Right, looks like this is my fault. I wasn't looking for the right thing. I guess I expected it to fail catastrophically if the infill was set too low, but actually on closer inspection I can see very fine holes in the prints below 0.8, it's like an extremely fine mesh. Also after the cubes cooled a...

CRNorris

Hi, I've just started using Simplify3D with my Flashforge Creator Pro, which I've always had trouble with in terms of extrusion volume. Someone on the Flashforge site recommended I calibrate the volume, which in Simplify3D can be done by repeatedly printing calibration cubes with 100% infill and twe...

Search found 4 matches

Reduce build voume to compensate for large fan duct

Live Preview Tracking Lags Behind Printer

Re: FF Creator Pro and Extrusion Multiplier

FF Creator Pro and Extrusion Multiplier