Search found 3 matches
- Tue Dec 30, 2014 5:15 pm
- Forum: General Discussion and Tips
- Topic: Nylon Bridge print settings
- Replies: 10
- Views: 12048
- Jump to post
Re: Nylon Bridge print settings
Well, I have tried everything I can think of and can't get it to work with simplify3d. retraction, coast , and wipe have all been taken to relatively extreme settings with little or no change. If I run it through replicator G it doesn't string, but the print quality isn't as good. Does anybody have ...
- Tue Dec 23, 2014 3:35 pm
- Forum: General Discussion and Tips
- Topic: Nylon Bridge print settings
- Replies: 10
- Views: 12048
- Jump to post
Re: Nylon Bridge print settings
I thought the point of bridge was that you didn't have to dry it. oh well. Into the toaster oven it goes
Thanks
Thanks
- Sat Dec 20, 2014 3:03 pm
- Forum: General Discussion and Tips
- Topic: Nylon Bridge print settings
- Replies: 10
- Views: 12048
- Jump to post
Nylon Bridge print settings
I am trying to get away from the stringing on Taulman bridge nylon, and cant seem to completely eliminate the blobs on extruder moves across the part. What are you using as far as settings in your prints. using a Wanhao dual printer Extruder Temp HBP temp Retraction Coast Funny thing is if I use Rep...
