Search found 3 matches
- Wed Dec 31, 2014 2:16 pm
- Forum: General Discussion and Tips
- Topic: How to insert GCode before the temperature commands?
- Replies: 5
- Views: 4437
- Jump to post
Re: How to insert GCode before the temperature commands?
The Taz 4 uses a RAMBo board running Marlin, doesn't it? I'd look at why the PID settings aren't saving instead of sending the values before every print. Have you contacted Lulzbot support? Are you issuing an M500 command to save the values after running the PID process? According to this post on t...
- Wed Dec 31, 2014 1:58 pm
- Forum: General Discussion and Tips
- Topic: How to insert GCode before the temperature commands?
- Replies: 5
- Views: 4437
- Jump to post
Re: How to insert GCode before the temperature commands?
Yes, there is a way! :D In the starting G-Code, G28; home all PID COMMAND M140 S[bed1_temperature] M190 S[bed1_temperature] M104 S[extruder0_temperature] M109 S[extruder0_temperature] Doing what you suggested (see attached screenshot) yields GCode that sets the bed temp, tries to wait for the bed t...
- Tue Dec 30, 2014 5:49 pm
- Forum: General Discussion and Tips
- Topic: How to insert GCode before the temperature commands?
- Replies: 5
- Views: 4437
- Jump to post
How to insert GCode before the temperature commands?
I'm using a Lulzbot Taz 4 and have had issues with Simplify3D and OctoPrint waiting forever to start the print because the factory PID values for bringing the bed temperature to the set point are off. As the bed temperature gets closer and closer to 60 (PLA in this instance), the rate at which it in...
