Simplify3D User Forum

adamfilip

Does v5 support duet / reprapfirmware firmware ?

adamfilip

I manually add mouse ears (10mm single layer circles) near the corners of my prints to help prevent warping. I prefer this over a brim as its on in select areas, and requires less cleanup wish there was a way to add automatically, and be able to specify spacing, diameter, layers, and offset from cor...

adamfilip

Often exterior dimensions are correct but holes are too small. should be a Dimensional Adjustment that just affects holes,

adamfilip

Hoping S3D will add support for machines with Belt Bed Z platform / Infinite bed. and printing on a 45 degree angle like this printer

https://printrbot.com/shop/printrbelt/

adamfilip

Trying to improve print quality with my Custom COREXY machine Running PETG at 255 degrees, with 70 degree PEI Bed I have also run at 235 degrees with similar print quality Extruder is a Bondtech Mini Direct Bowden Bowden tube is aprox 400mm E3D V6 Bowden 1.75 with .4mm nozzle Simplify 3D Settings .4...

adamfilip

yes but removing a brim for an entire model is a pain. easier to just remove a few disks.

adamfilip

I would like to be able to easly add a Brim or Mouse ears to spefici areas of the model to help prevent curling. or even better for it to be able to tell where curling might occur and automatically add them to those areas.

adamfilip

I would like to be able to run some custom code, at a set interval of layers that I set.

For example. If I wanted to add some code for the hotend to move X&Y over to a wiping station every 10 layers, to clean the Nozzle
and then continue back onto the next layer

adamfilip

tired printing the same file using the same settings with S3D 2.2 and no pauses.. works normal

adamfilip

Baud is set to 250000, same as it was with S3D 2.2
yes over USB, havent tried via SD card

Search found 18 matches

V5 duet/reprapfirmware support ?

Mouse Ears

Hole Adjust

Belt Z / Angled Head Support

Need some suggestions to improve print quality

Re: Feature Request : Mouse Ears

Feature Request : Mouse Ears

FEATURE REQUEST : Run Code every X layers

Re: S3D 3.01 Long Pauses - Makerfarm 12"

Re: S3D 3.01 Long Pauses - Makerfarm 12"