For next version it would be nice if this was fixed.Search found 6 matches
- Tue Apr 07, 2015 12:42 pm
- Forum: Feature Requests
- Topic: [ADDED] Better tab order in panels
- Replies: 3
- Views: 2275
- Jump to post
[ADDED] Better tab order in panels
The tab order (where cursor jumps when you press tab in a panel) is whacky, to say the least. For next version it would be nice if this was fixed.
For next version it would be nice if this was fixed.- Tue Apr 07, 2015 12:39 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Save to SD card = zero bytes
- Replies: 5
- Views: 4215
- Jump to post
Re: Save to SD card = zero bytes
I have the very same issue. Have to save to another place and then copy file over to SD card. Mac version 2.2.2, Vertex printer.
- Mon Feb 02, 2015 10:28 am
- Forum: General Discussion and Tips
- Topic: Tip of the Day 12- Vase Mode
- Replies: 12
- Views: 102358
- Jump to post
Re: Tip of the Day 12- Vase Mode
Another question about vase mode - what settings should I change when vase comes out leaky? My bottom layers doesn't fill completely apparently. It's when the infill layer meets the perimeter at certain angles that very tiny holes appear. I've tried increase extrusion and add another layer but that ...
- Mon Feb 02, 2015 9:54 am
- Forum: General Discussion and Tips
- Topic: Tip of the Day 12- Vase Mode
- Replies: 12
- Views: 102358
- Jump to post
Re: Tip of the Day 12- Vase Mode
It's probably going slow for cooling. You need to make sure the plastic has time to cool before the next extrusion is placed on top of it. But you can always disable of modify these settings by click Edit Process Settings and then choosing the Cooling tab. You can disable it completely by uncheckin...
- Sun Feb 01, 2015 1:03 pm
- Forum: General Discussion and Tips
- Topic: Tip of the Day 12- Vase Mode
- Replies: 12
- Views: 102358
- Jump to post
Re: Tip of the Day 12- Vase Mode
Great tip! One thing though: what's with the print speed when printing in vase mode? It's horribly slow, like 10 mm/s. Is that what I should expect or have I missed some setting?
- Thu Jan 29, 2015 8:44 am
- Forum: General Discussion and Tips
- Topic: Settings for Vellemann Vertex K8400
- Replies: 5
- Views: 9087
- Jump to post
Re: Settings for Vellemann Vertex K8400
Nice with a Vertex thread! I've just started printing and there is obviously need for a lot of tuning to get the optimal print. With the default settings for K8400 I get too thick walls so part within parts that should be moving gets stuck in each other. I have tested with lowering the flow and that...
