Simplify3D User Forum

Phil M

Reading http://forum.simplify3d.com/viewtopic.php?f=9&t=735 it looks like users have found the real problem - S3D pauses the print head while retracting, while other slicers continue motion while retracting, and the pause causes the blobs. Looks like there's a script to modify the gcode to remo...

Phil M

I finally got it to connect
Turns out all i had to do was in Tool> Firmware configuration>Communications ...was turn off ( un-check) the "wait for startup command"

Thanks for pointing me in the right direction BaudR8

Phil M

i have a similar issue. S3D wont connect to my printer . Pronterface works fine so im confident the com port / baud rate are fine. Any ideas ?? Thanks If the machine control panel sees the correct COM port, but you are unable to connect to the machine, I have seen some cases where people solved thi...

Phil M

What printer are you using? But more importantly, what settings are you using? Are these profiles that you made on your own? It looks like you definitely have some bad retraction/ooze settings Oops rookie mistake ...filament was set to 1.75 instead of 3mm. Now we know what that looks like 8-) Could...

Phil M

i have a similar issue. S3D wont connect to my printer .
Pronterface works fine so im confident the com port / baud rate are fine.
Any ideas ??

Thanks

Phil M

Same problem here

Just started using S3D and a bit disappointing so far. Blobs all over the place ...see pic.

3 models ...orientated as printed 2 on left S3D ...1 on the right Cura no support !
Same machine, same filament , same speed , retraction, temp , layer height etc etc

Any ideas ????

Search found 6 matches

Re: blobs

Re: version 2.2 not see my printer, 2.1 see it...

Re: version 2.2 not see my printer, 2.1 see it...

Re: blobs

Re: version 2.2 not see my printer, 2.1 see it...

Re: blobs