Search found 8 matches
- Wed Feb 11, 2015 1:55 am
- Forum: General Discussion and Tips
- Topic: Gcode Drop in Variables.
- Replies: 2
- Views: 3685
- Jump to post
Re: Gcode Drop in Variables.
would be very handy. lease
- Wed Feb 11, 2015 1:48 am
- Forum: Troubleshooting and Bug Reports
- Topic: Approach overhangs fron a non overhang direction
- Replies: 3
- Views: 2210
- Jump to post
Re: Approach overhangs fron a non overhang direction
Using ABS juice to stick things down. I can normally print quite large objects without it being knocked off. The problem probably arise when moving (100mm/s) to a new position to start printing and the head moves over a curled up section (where there is overhang without support) on a section higher ...
- Wed Feb 11, 2015 1:38 am
- Forum: Feature Requests
- Topic: Auto fine layers only when needed
- Replies: 2
- Views: 2186
- Jump to post
Re: Auto fine layers only when needed
Using different processes do help in this regard but then the whole section of the model need to be printed that way slowing things down. Also using different processes one need to find & define the ranges manually. The interfaces between layers also tend to be printed with 100% infill (or one m...
- Tue Feb 10, 2015 8:17 am
- Forum: Feature Requests
- Topic: Single thickness walls (Spurs)
- Replies: 11
- Views: 10695
- Jump to post
- Tue Feb 10, 2015 6:13 am
- Forum: Troubleshooting and Bug Reports
- Topic: Approach overhangs fron a non overhang direction
- Replies: 3
- Views: 2210
- Jump to post
Approach overhangs fron a non overhang direction
I'm printing mostly with ABS. Great for printing overhangs without support but due to the slight up-curl and the speed of printing it sometimes happen that the model is bumped off the build plate. A way around this is to use z-lift. This do however slow down my printing time considerably. Would it b...
- Tue Feb 10, 2015 6:06 am
- Forum: Troubleshooting and Bug Reports
- Topic: Wipe While Retracting...
- Replies: 42
- Views: 45576
- Jump to post
- Tue Feb 10, 2015 6:04 am
- Forum: Troubleshooting and Bug Reports
- Topic: vase mode and wipe
- Replies: 2
- Views: 1778
- Jump to post
- Tue Feb 10, 2015 6:01 am
- Forum: Feature Requests
- Topic: Auto fine layers only when needed
- Replies: 2
- Views: 2186
- Jump to post
Auto fine layers only when needed
Can you add the option to automatically reduce layer height for high "overhang" areas to 1/2, 1/3 or 1/4 of current layer. This only need to be done on areas where the angle more than a specified angle (say 30deg or so). This will allow for much smoother finishing yet allow maximum speed o...
