Search found 3 matches

Go to advanced search

by JohnnyRobot
Fri Feb 27, 2015 10:12 am
Forum: Feature Requests
Topic: Fill voids with infill, or print support material as infill.
Replies: 2
Views: 1325

Re: Fill voids with infill, or print support material as inf

I thought about that also, With infill, you can specify the rectilinear pattern, and I think the resolution would be higher as well. You'd be able to get into the tight corners. Well, that, and if you actually needed to use support material... You would have a very difficult time removing it. It wou...
by JohnnyRobot
Thu Feb 26, 2015 4:38 pm
Forum: Feature Requests
Topic: Fill voids with infill, or print support material as infill.
Replies: 2
Views: 1325

Fill voids with infill, or print support material as infill.

I would like to see an option to fill part voids with infill, instead of support material. I work on a lot of components for RC aircraft. It's sometimes difficult to find the right strength to weight ratio. It would be nice to be able to design a structure with internal voids with the ability to pri...
by JohnnyRobot
Thu Feb 26, 2015 11:40 am
Forum: Feature Requests
Topic: Slow down for small loops?
Replies: 68
Views: 38620

Re: Slow down for small loops?

We use this in robotics. Small Circle Accuracy. When a small circle is detected, decrease the speed. We use 3X diameter (10mm = 30mm sec.) perhaps it can be adjustable in S3D. "Print circles less than Xmm diameter at Y * Diameter speed"

Go to advanced search