Search found 5 matches
- Fri Mar 20, 2015 4:53 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Wipe While Retracting...
- Replies: 42
- Views: 67792
- Jump to post
- Fri Mar 20, 2015 4:47 pm
- Forum: Troubleshooting and Bug Reports
- Topic: infill mess
- Replies: 6
- Views: 3176
- Jump to post
Re: infill mess
@Jimmy, I think that's not the problem (earlier, we had to made some improvements to centre the filament cilinder and to prevent the filament wire to come loose too much from the cilinder while feeding) Latest test was much better; bed 85 nozzle 250 infill 35% infill width 300% speed (7000 from 1200...
- Wed Mar 18, 2015 11:53 am
- Forum: Troubleshooting and Bug Reports
- Topic: infill mess
- Replies: 6
- Views: 3176
- Jump to post
Re: infill mess
Hi Joe,
Yep, you are right.
Increasing the temperaturen of the nozzle gave an improvement, but not good enough, yet.
Doing a new test on half speed, now
Tnx,
Rene
Yep, you are right.
Increasing the temperaturen of the nozzle gave an improvement, but not good enough, yet.
Doing a new test on half speed, now
Tnx,
Rene
- Tue Mar 17, 2015 7:58 pm
- Forum: Troubleshooting and Bug Reports
- Topic: infill mess
- Replies: 6
- Views: 3176
- Jump to post
Re: infill mess
Tnx Joe for your answer. Well, There is a setting for the infill speed; by default it is on 80% of the standard speed. It is on the tab where you can define the different speed settings So that's why I thought lowering the infill speed might help. I think I already tried to make the infill extrusion...
- Mon Mar 16, 2015 7:48 am
- Forum: Troubleshooting and Bug Reports
- Topic: infill mess
- Replies: 6
- Views: 3176
- Jump to post
infill mess
Hi, We are using simplify3D. Printing the infill becomes a mess. The infill lines don't stick to the underlying level well enough. See picture. ABS, bed 80 degrees, nozzle 230 degrees, infill speed 50%. Fiddling with the 23000 parameters doesn't seem to improve much. The problem has two aspects; de ...
