Simplify3D User Forum

StealthMicro

I think this is somewhat a symptom of how the whole program has been designed....ie by a programmer, not by a user! PAUSE - stop issuing commands to the printer in anticipation of there being a restart STOP - Stop issuing commands to the printer. Full stop! EMERGENCY STOP - Abort the print process,...

StealthMicro

Any suggestions here?

StealthMicro

Windows 7 64bit S3D 2.2.2 IOGear 4 Port USB to Ethernet/WiFi (mine is connected to ethernet) Sailfish 7.7 r01432 1st try preheating... STOP... Does not stop the pre heat process. Must disconnect and reconnect to proceed. When trying to print from the reconnect steppers move slow and sound distressed...

StealthMicro

If for some reason I need to stop the build by pressing the STOP button not the EMERGENCY STOP just the normal STOP button it stops the build but I can not start another build unless I hit the Disconnect button and then the Reconnect button before clicking the Begin Printing over USB. If I do it doe...

StealthMicro

That'll definitely work! For the top part, you could just double-click your model and drop it 65 mm below the bed. The slicer won't slice anything below your bed, so in the G-Code created (you can verify this in the previewer), it'll just print the top portion. But the way you described will work a...

StealthMicro

Figured out how to do it. Not sure if it is recommended but seems to work just fine. So lets say I want to print a Stanley cup to 9 inches. I can simply scale the model appropriately then find a good place to split the print that will glue together good. Lets say that I determine that 65mm is a good...

StealthMicro

I have a model that is too tall for my build platform. Can I tell S3D to print to X height first then tell it to start printing from X height but to start the build on the build platform and not in mid air?

StealthMicro

For those just starting out trying to setup S3D with a Replicator 2 and HBP... Racked my brain for a while on this so let me give my settings for any new people who have this setup. First setup your bot using HELP > Configuration Assistant > Makerbot Replicator 2 then... Tools > Firmware Configurati...

StealthMicro

Go to Tools > FIrmware Configuration, and under the X3G tab, make sure you have Replicator 2 with HBP selected. In your FFF Settings, add a temperature controller in the Temperature tab, and make sure the type is heated build platform. Then in your starting G-Code, find where it says: M104 S[extrud...

StealthMicro

I have a replicator 2 with a HBP installed. The issue I have is when ever I go to print it heats the build plate up to what ever the preheat settings in the firmware are, Instead of S3D controlling the temperature I have to change it in the preheat settings on the control panel of the bot itself. I ...

Search found 14 matches

Re: Must disconnect and reconnect -S3D 2.2.2 - Replicator 2

Re: Must disconnect and reconnect -S3D 2.2.2 - Replicator 2

Re: Must disconnect and reconnect -S3D 2.2.2 - Replicator 2

Must disconnect and reconnect -S3D 2.2.2 - Replicator 2 HBP

Re: Split one large model and glue together.

Re: Split one large model and glue together.

Split one large model and glue together.

Re: Replicator 2 with HBP Settings

Re: Replicator 2 with HBP - Preheats bed always.

Replicator 2 with HBP - Preheats bed always. SOLVED