Search found 4 matches
- Sat Oct 05, 2019 1:33 am
- Forum: Troubleshooting and Bug Reports
- Topic: FlashForge Dreamer USB Printing Filenames
- Replies: 0
- Views: 3252
- Jump to post
FlashForge Dreamer USB Printing Filenames
I recently upgraded from Simplify3D version 3.x to 4.x. Prior to 4.x, when I would do a print over USB, S3D would write the gcode file to a file called "temp" in the Dreamer's internal memory. In version 4.x, S3D now writes each print to a filename that starts with "Print_" and t...
- Sun Sep 27, 2015 2:35 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Flashforge Dreamer Firmware 2.4 Problems
- Replies: 21
- Views: 27500
- Jump to post
Flashforge Dreamer Firmware 2.4 Problems
I updated my Flashforge Dreamer to firmware version 2.4. There's a warning in the changelog for version 2.4 which states: "Warning: Users must use the Flashprint software higher than version 3.4.1 after updating firmware, otherwise WIFI is unavailable for file transfer." Apparently this me...
- Mon Apr 20, 2015 11:36 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Flashforge Dreamer Save to Local Memory
- Replies: 2
- Views: 2261
- Jump to post
Re: Flashforge Dreamer Save to Local Memory
This makes sense and worked great, thanks!
- Mon Apr 13, 2015 10:06 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Flashforge Dreamer Save to Local Memory
- Replies: 2
- Views: 2261
- Jump to post
Flashforge Dreamer Save to Local Memory
When I print to my Flashforge Dreamer using FlashPrint (the default slicer software), it sends the G-code to the printer, where it both prints and saves the file in the printer's local memory (on an "internal" SD card, not the external SD card). If I do the same thing with Simplify3D, the ...
