Search found 3 matches
- Thu Jun 14, 2018 6:22 am
- Forum: Troubleshooting and Bug Reports
- Topic: Impossible to remove retraction defects with S3D
- Replies: 17
- Views: 29752
- Jump to post
Re: Impossible to remove retraction defects with S3D
Came across this thread whilst suffering from the same artifacts on exterior surface of prints .. They showed up in the preview as well.. Machine is a Kossel XL with a bowden, so retraction set to 5mm etc for normal bowden operation ... I turned off the 'coast at end' setting and they vanished in th...
- Tue Aug 25, 2015 10:02 am
- Forum: Troubleshooting and Bug Reports
- Topic: Only thin air remains!
- Replies: 3
- Views: 4094
- Jump to post
Re: Only thin air remains!
thanks for the reply, much appreciated ! the item itself is an earring, and the top loop afaik should be at least 0.5 mm to 1mm thick i think, so printing at 0.1 per layer should be easily achievable i would think .... I got the model from instructables, and there seem to be a number of folks who ha...
- Tue Aug 25, 2015 4:41 am
- Forum: Troubleshooting and Bug Reports
- Topic: Only thin air remains!
- Replies: 3
- Views: 4094
- Jump to post
Only thin air remains!
hi folks, printed this part without checking the stl preview ... then wondered where the top loop was ... checking the preview in S3d , using standard PLA/Fine settings for a duplicator 4s ... and for some reason, there is a huge gap between the loop and where it is meant to be connected , so now im...
