Search found 4 matches
- Thu Aug 06, 2015 3:42 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Bridging issue
- Replies: 2
- Views: 2021
- Jump to post
Re: Bridging issue
I guess I posted the thumbnail of the image... this might be better:
- Thu Aug 06, 2015 3:37 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Bridging issue
- Replies: 2
- Views: 2021
- Jump to post
Bridging issue
http://www.thingiverse.com/thing:910216 When printing the above model, there are two areas which are bridged. The S3D slicer appears to do something strange during the bridge which results in filament being dropped underneath. https://lh3.googleusercontent.com/-TupNBv7Ibtw/VcO2WPNpXLI/AAAAAAAAALI/Pl...
- Mon May 04, 2015 7:57 am
- Forum: General Discussion and Tips
- Topic: Delta an Smothie
- Replies: 2
- Views: 1433
- Jump to post
Re: Delta an Smothie
Thanks,
I searched but could not find and 'smoothie' posts.
What about bed leveling, is there any support for that?
Thanks
Phil
I searched but could not find and 'smoothie' posts.
What about bed leveling, is there any support for that?
Thanks
Phil
- Sun May 03, 2015 12:34 pm
- Forum: General Discussion and Tips
- Topic: Delta an Smothie
- Replies: 2
- Views: 1433
- Jump to post
Delta an Smothie
Hi, I have mini Kossel Delta with a Ramps, which is working quite well at the moment. I drive this with Repetier and Slic3r which also do a reasonable job. I recently purchased a Smoothie board which I have not installed yet. Question(s): 1. will Simplify3D work well with Ramps? 2. when I upgrade to...
