Search found 2 matches
- Mon May 11, 2015 9:34 am
- Forum: General Discussion and Tips
- Topic: Vertical Layer Quality
- Replies: 2
- Views: 857
- Jump to post
Re: Vertical Layer Quality
Thanks for the quick reply JoeJ. I appreciate the advice! Admittedly, I have not tried a brim on my parts, because I was concerned about that the lower layers of my parts, which have thin (30-40mil wide) walls on the top and bottom. I suppose there is nothing wrong about trying a few prints. I also ...
- Sun May 10, 2015 9:29 pm
- Forum: General Discussion and Tips
- Topic: Vertical Layer Quality
- Replies: 2
- Views: 857
- Jump to post
Vertical Layer Quality
Greetings, I am new to 3D printing, but have done my reading and research and can't seem to figure out how to solve my problem. Any help is much appreciated. Working with ABS, my prints are, for the most part, clean, with smooth walls, edges and corners. I have been testing and tweaking settings, i...
