Search found 6 matches

Go to advanced search

by ftherrmann
Thu Jun 27, 2019 6:46 pm
Forum: Feature Requests
Topic: SLA Printing???
Replies: 4
Views: 1200

SLA Printing???

While Chitubox works well I've found that Simplify3D always works better than the competition..

Any chance of supporting SLA printers such as the Photon and Photon S?

TIA
by ftherrmann
Sat May 23, 2015 6:18 pm
Forum: General Discussion and Tips
Topic: manually defined support not showing up?
Replies: 5
Views: 1096

manually defined support not showing up?

I have support enabled and the 4 manual supports I added show up before slicing. After slicing only two of the supports show up and they are not touching the arch that needs support. I've tried changing the angle in the auto support tab, but I'm not seeing anything different. Please see the two scre...
by ftherrmann
Wed May 20, 2015 10:39 am
Forum: General Discussion and Tips
Topic: How to remove a problem layer from a part?
Replies: 2
Views: 671

Re: How to remove a problem layer from a part?

Didn't know you could do that. RepG would run the nozzel into the table if you started below. I also remembered/was told that you can also start at a certain height. If you look really close at the raft you'll see that it first prints a partial heart raft about 1/6th the size of the entire piece. Th...
by ftherrmann
Tue May 19, 2015 9:52 pm
Forum: General Discussion and Tips
Topic: How to remove a problem layer from a part?
Replies: 2
Views: 671

How to remove a problem layer from a part?

I don't think this feature is available from within S3D but maybe someone could advise me of a good program to use in order to fix this problem .stl file. Like many parts I've downloaded a lot of parts don't have a flat edge. In this particular .stl file there are a couple of partial layers on the "...
by ftherrmann
Tue May 19, 2015 9:46 pm
Forum: General Discussion and Tips
Topic: S3D Doesn't know Table Size...
Replies: 6
Views: 977

Re: S3D Doesn't know Table Size...

Thanks for the posts.. I was comparing it to RepG and the nozzel cleaning off the table threw me. S3D seems to work fine now, just need to get my table and extrude temps figured out.

Thanks,

Fred
by ftherrmann
Mon May 18, 2015 12:54 pm
Forum: General Discussion and Tips
Topic: S3D Doesn't know Table Size...
Replies: 6
Views: 977

S3D Doesn't know Table Size...

Bought S3D yesterday. I put in a support ticket for the table size problem yesterday and also searched the forum and also watched some S3D setup videos that deal specifically with S3D and the FF Creator. Still haven't found the fix for the problem. Here's my setup... Flashforge Creator Pro Here's my...

Go to advanced search