Simplify3D User Forum

rsteckler

Hi, I have a FlashForge Creator Pro running Sailfish 7.4. Simplify3d works great for printing, but today I was trying to manually load some ninjaflex using the control panel by heating up the extruder, then extruding slowly step by step. Everything worked in the control panel - jog controls, fan con...

rsteckler

I think support infill dictates the degree of the support material itself, right?

I'm looking to change the angle of the bottom layer that's sitting on top of the supports to 45 degrees (like all the rest of the bottom layers).

Here's the picture again with comments to hopefully better explain.

rsteckler

The screenshot attached is from the bottom, looking up through the floor of a print preview. As you can see, Simplify3d is laying down my bottom layers that touch the bed at a 45 degree angle (which works well). But then you can see an overhang on top of some support that prints the bottom layer at ...

rsteckler

It's hard for me to tell what they've changed and when. I know some things, though: The bed now comes with a blue plastic base, and a few extras (instead of kapton tape) There's a fan on each print head, plus a fan to the left side of the assembly that pushes the air forward. This side-fan may be th...

rsteckler

Hi - My new FFCP doesn't work well with the stock S3D profile. I think FF made some changes recently. First, the nozzle purge happens on the table. In fact, if you jog the print head all the way to the left, the right side (default) nozzle is still over the table. It's physically not able to get off...

Search found 5 matches

Control Panel Extrude corrupts communication

Re: Bottom layer on support - 0 angle?

Bottom layer on support - 0 angle?

Re: New FlashForge Creator Pro X Offset problem

New FlashForge Creator Pro X Offset problem