Search found 4 matches
- Fri Jun 19, 2015 2:18 pm
- Forum: General Discussion and Tips
- Topic: CubePro Compatibility
- Replies: 76
- Views: 102476
- Jump to post
Re: CubePro Compatibility
I do think you might just be a touch too close to the plate. You might want to try about a 1/4 turn on the plate on each knob, or as the manual likes to say, "two steps". You should also note, I start printing at .4mm and print each layer at .1250 mm. You could also just go to advanced and...
- Thu Jun 18, 2015 5:29 pm
- Forum: General Discussion and Tips
- Topic: CubePro Compatibility
- Replies: 76
- Views: 102476
- Jump to post
Re: CubePro Compatibility
Hello, I need your help again ! The printer works fine with the current parameters but there is a little problem with the last perimeter extruded. As you can see on the following picture, the last perimeter quality is bad compare to the first (the outside perimeter is the first printed and the insi...
- Sun Jun 07, 2015 6:38 pm
- Forum: General Discussion and Tips
- Topic: CubePro Compatibility
- Replies: 76
- Views: 102476
- Jump to post
Re: CubePro Compatibility
So couple of things, as MichaelHerron mentioned, I do start my index's at 1 instead of 0. It makes the code simple to follow as "tool1" is also "index1" , so those who are looking, please note that in the extruder settings, I do override the default index. Next up as MichaelHerro...
- Sun May 31, 2015 2:39 pm
- Forum: General Discussion and Tips
- Topic: CubePro Compatibility
- Replies: 76
- Views: 102476
- Jump to post
Re: CubePro Compatibility
Hey all, I just saw this post and thought I'd share some stuff with all of you. I've got a cubePro with 3 printheads and have done a TON of printing / test prints to figure out settings that work best for me. I've attached my base .frm which is a very generic base firmware, as well as several of my ...
