Search found 2 matches
- Tue Jun 16, 2015 8:57 pm
- Forum: Troubleshooting and Bug Reports
- Topic: support settings
- Replies: 3
- Views: 1150
- Jump to post
Re: support settings
JoeJ, thanks for the reply.. I was able to get excellent results by adjusting the dense support.. I am very interested in learning more about printing with multiple extruders, especially with the scenario you mention using a non-fusing support filament.. I've looked a bit, but not finding much in th...
- Sat Jun 13, 2015 3:46 pm
- Forum: Troubleshooting and Bug Reports
- Topic: support settings
- Replies: 3
- Views: 1150
- Jump to post
support settings
Hello, I am starting out using S3D on a Robo 3D, and getting very good results except where my support structures support the print in certain areas.. As shown in the image, the arms are missing lower sections, more on one side than the other.. I believe it is because I have the "Support Materi...
