Simplify3D User Forum

Grifftech

Was easy to do in 4 but can't find it in 5

Grifftech

Hello, I am using S3D 5.0.2 with the P1P. I also transfer the programs with the SD card. I have tried several times to establish a connection, unfortunately without success. I am trying to establish a connection to the SD card. According to the internet it should work like this: ftp://"WLAN IP...

Grifftech

I am trying to figure out if I can send the gcode files through the Bambu Studios wirelessly to the printers or do I have to load the files manually on the tiny SD cards?

Grifftech

I upgraded from Windows 8.1 with a 4 core CPU and 8GB of memory to Windows 10 with a 12 core CPU and 64GB of memory and S3D is terribly slow. I don't see how it can be the new hardware but maybe Windows 10?

Grifftech

I want to be able to use my S3D at work and at home, is that possible to do with one license?

Grifftech

I have a couple sections on my print that when the extruder moves from support material to the main print it is leaving tons of strings behind, but in places where the head moves over open area from main print to main print the retraction is awesome. I am not sure what is going on. Thanks for any tips

Grifftech

Whether the box is unchecked or checked and I set the value to 999, the travel moves do not change a bit and it still crosses all the open spaces

Grifftech

I using the dual extrusion wizard and I place my supports manually but when I run Prepare to Print it places supports all over where I do not want them. Also when I have a support that crosses the place where the two pieces meet, why wont one extruder start the support and the other finish it?

Grifftech

I don't want dense on the bottom because it will stick to my print too much. This is for supports that don't touch the bed

Grifftech

Is there a way I can force the tool head to move along the outside perimeter when doing a non-print move in S3D? I am printing a flat key chain fob with a hole on one side in TPU and the tool head when cross the main body of the print after it finishes a layer to get to hole to do its perimeter and ...

Search found 60 matches

How do I export supports in S3D 5?

Re: Anyone using 5.0.2 with Bambu P1P

Anyone using 5.0.2 with Bambu P1P

S3D 3 times slower slicing on new system

Can I use my license on two computers

Retraction doesn't seem to work when moving from support

Avoid Crossing Outline doesn't appear to do anything

Supports and Dual extrusion

Can I make Dense Infill Layers only on top of support??

Tool head pathing question