Search found 3 matches
- Wed Feb 08, 2017 10:49 pm
- Forum: General Discussion and Tips
- Topic: Wobbly Edge
- Replies: 2
- Views: 1697
- Jump to post
Re: Wobbly Edge
How about your leveling? That corner could be higher causing the filament to have enough slack that it start wobbling. Blobs are always cause by improper FFF settings. It could be retraction, temperature and where you start the print for each layer. The outer perimeter has different speeds from the ...
- Wed Jun 15, 2016 11:03 pm
- Forum: Feature Requests
- Topic: [ALREADY ADDED] Per layer options for all settings
- Replies: 1
- Views: 810
- Jump to post
[ALREADY ADDED] Per layer options for all settings
It would be nice if the per layer calibration such as the temperature could also apply to all the setting. For example i have a part that at the bottom is thick and prints very well at a certain setting, but then after a certain layer the model is no longer thick and its series of small pillars. To ...
- Mon Jun 22, 2015 2:05 pm
- Forum: Feature Requests
- Topic: Features that would improve the software.
- Replies: 5
- Views: 2571
- Jump to post
Features that would improve the software.
1) Different infill paterns 2) Lay flat feature 3) Zoom to where the mouse is pointing ,not to the center of the screen. This would require less use of the pan feature and make the navigation smoother 4) Copy paste model with a single shortcut instead of having to import the same model multiple time...
