Search found 3 matches
- Tue Oct 27, 2015 12:02 am
- Forum: Troubleshooting and Bug Reports
- Topic: First layer speeds up after support is started
- Replies: 2
- Views: 1145
- Jump to post
First layer speeds up after support is started
I have had a couple of prints that wouldnt print properly. So, I sat and watched the start of the print. I typically have the first layer go at 20% speed. The object has three posts in a triangular pattern with support in between. The start of the first post is fine. Then, some of the support is lai...
- Thu Jul 09, 2015 5:14 pm
- Forum: General Discussion and Tips
- Topic: Top Layer not really solid
- Replies: 6
- Views: 7517
- Jump to post
Re: Top Layer not really solid
I did come across that other post. However, the response is one that I already tried. One of the first things I did was to increase the extrusion multiplier. That works fine for the first and last layer if I increase it a fair amount. However, other features end up suffering. As an example, I have s...
- Thu Jul 09, 2015 12:27 pm
- Forum: General Discussion and Tips
- Topic: Top Layer not really solid
- Replies: 6
- Views: 7517
- Jump to post
Top Layer not really solid
I'm relatively new to S3D. I have used Cura for a few years not and have decided to try S3D. In S3D, I have settings for 3 solid bottom layers and top layers. There is a setting to set the extrusion %, width, etc. for the bottom layer adn I typically will jack those up to make sure the print sticks ...
