Search found 6 matches

Go to advanced search

by jcullins
Fri Mar 25, 2016 3:48 pm
Forum: General Discussion and Tips
Topic: Profiles & Filaments
Replies: 3
Views: 1556

Re: Profiles & Filaments

I use a ROBO3d with auto level. I just got a roll of eSUN PETG , I used the stock ABS settings and got good results.
I was amazed the dimensions were very good. I printed a 1inch cube it measured 1.02, 1.02, 1.05 .
My question, is there a profile that you recommend for PETG?
by jcullins
Thu Nov 12, 2015 10:28 am
Forum: General Discussion and Tips
Topic: New Extruder recommendations please :)
Replies: 2
Views: 471

Re: New Extruder recommendations please :)

It may not be the extruder, it may be the MOSFET driving it.
in answer to you question I like the E3d v6. search youtube for videos on it.
by jcullins
Thu Nov 12, 2015 9:39 am
Forum: General Discussion and Tips
Topic: Tip of the Day 4- Layer tab, a technical analysis
Replies: 14
Views: 46153

Re: Tip of the Day 4- Layer tab, a technical analysis

I don't see a setting for flexible filament , What would change from ABS.
by jcullins
Wed Aug 26, 2015 4:24 pm
Forum: General Discussion and Tips
Topic: Tip of the Day 4- Layer tab, a technical analysis
Replies: 14
Views: 46153

Re: Tip of the Day 4- Layer tab, a technical analysis

Okay, so you recommend just going with the default for my printer (Robo3d r1 with auto level) and the material type.
easy enough. I am very new to this so I do have a lot to learn.
Thanks
by jcullins
Wed Aug 26, 2015 8:24 am
Forum: General Discussion and Tips
Topic: Tip of the Day 4- Layer tab, a technical analysis
Replies: 14
Views: 46153

Re: Tip of the Day 4- Layer tab, a technical analysis

I see in the tab screen shot this is for PLA, what changes would be made for ABS or nylon ?
Great tips. I bought a Robo3d R1 with auto-leveler about 2 months ago, lots to learn. Thanks
by jcullins
Thu Jul 16, 2015 2:11 pm
Forum: General Discussion and Tips
Topic: One layer error
Replies: 6
Views: 763

Re: One layer error

could be your table caught on something so did not move up to next layer.... I am new but just a thought

Go to advanced search