Search found 3 matches
- Fri Aug 11, 2017 12:32 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Connect to Printer over Wifi from S3D
- Replies: 0
- Views: 2654
- Jump to post
Connect to Printer over Wifi from S3D
I have a Creality CR10 printer. Have Octopi installed Raspberry Pi 3 iMac Computer Simplify3D 4.0 I can connect to the Octopi by typing the IP address into my browser and logging on. I can print through the Octopi and watch the Camera on the printer. What I would like to do is be able to Add a Port ...
- Wed May 17, 2017 10:16 am
- Forum: General Discussion and Tips
- Topic: Rostock Max V3 Dual Extruder
- Replies: 0
- Views: 932
- Jump to post
Rostock Max V3 Dual Extruder
Does anyone have this printer with the Dual Extruder Update? If so, do you have a profile for PLA that is giving good prints. I could sure use one from someone that has already gone through all the trial and error. I have a new one just assembled and it isn't printing good prints. Here is an example...
- Mon Oct 26, 2015 1:16 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Very Rough Edges on Robo 3D R1 Plus
- Replies: 1
- Views: 1064
- Jump to post
Very Rough Edges on Robo 3D R1 Plus
On my prints, as you can see, the sides are coming out extremely rough. The bottom layers are smooth, but when it starts building the sides, it lays out the 2 outside beads smooth, then when it fills in between those beads, it shakes/vibrates and seems to push out the smooth outside beads causing th...
