Simplify3D User Forum

ddnguyen_278

Changing the support infill angle doesn't create non-90 degree supports from what i can tell. I'll try a print with it to see but from the pre-viz it looks exactly the same.

ddnguyen_278

Is that what it's doing when it wiggles back and forth violently around the perimeters? Yah it's probably not doing the printer any good.

ddnguyen_278

Will do, here's the factory file note the support for her right arm, they are being printed outside the raft in mid air initially which causes them to fail. I'm using 2 processes because I want the upper body to be printed at high detail while lower body at medium detail.

ddnguyen_278

It would be nice to let the user specify the angle at which the support spans instead of the straight up 90 degrees they do now. I tried printing the mammoth skeleton from the Smithsonian and its 95% supports based on mass. There just isn't an option to create a tree like support structure to reduce...

ddnguyen_278

When printing with multiple processes on a single model with the raft option on, some of the supports are left orphaned outside the raft area and are printed above air sometimes. There seems to be some issue with raft generation and support generation in multi-process prints.

ddnguyen_278

I'm trying to print a model with 2 regions, with the auto-generated raft + supports. The supports on the 2nd level don't generate a raft under them and also it seems that after printing the raft the print head moves down to the 0 level to print the supports which scrapes and destroys the raft it jus...

Search found 6 matches

Re: Support generated at arbitrary angles other than 90

Re: Infill underspeed

Re: Multi-Process prints Raft and Support problems

Support generated at arbitrary angles other than 90

Multi-Process prints Raft and Support problems

[FIXED] Raft not generated under support for multi-region