Search found 6 matches

Go to advanced search

by CCVirginia
Thu Aug 27, 2015 2:15 pm
Forum: Feature Requests
Topic: Explicit control of multiple surface types
Replies: 0
Views: 410

Explicit control of multiple surface types

This is a specific feature request as a follow-on to topic: https://forum.simplify3d.com/viewtopic.php?f=9&t=3357 Simplify provides controls for various surfaces, such as top/bottom, infill, etc. However, there is insufficient and inconsistent control for all surface kinds. The request is to identif...
by CCVirginia
Tue Aug 25, 2015 9:57 am
Forum: Troubleshooting and Bug Reports
Topic: Horizontal-supported surfaces.
Replies: 4
Views: 1394

Re: Horizontal-supported surfaces.

I suspect this is an "infill" issue, not a support issue for 2 reasons: 1) The much better print used the same support but changed the outline shell layers to eliminate infill. While there are a few rough spots (as would be expected), this print has a "tight" bottom. 2) There are 2 versions of this ...
by CCVirginia
Mon Aug 24, 2015 11:56 pm
Forum: General Discussion and Tips
Topic: Top Layer Angle
Replies: 4
Views: 895

Re: Top Layer Angle

+1

Also, consider settings for "suspended bottoms" as are found over a support or as a bridge. Settings could include angle, pattern, speed and extrusion.
by CCVirginia
Sun Aug 23, 2015 2:15 pm
Forum: Troubleshooting and Bug Reports
Topic: Horizontal-supported surfaces.
Replies: 4
Views: 1394

Horizontal-supported surfaces.

On several models that have horizontal or near horizontal overhang I am getting an odd pattern of single threads, even with support (See picture - center of Guantlet). The horizontal area over the overhang is VERY rough. It seems like the way S3D handles this situation is not the best. I have tried ...
by CCVirginia
Mon Jul 20, 2015 11:21 am
Forum: Feature Requests
Topic: Print log
Replies: 1
Views: 800

Print log

It is often necessary to try a lot of settings for various filaments and prints and it can be a lot to keep track of. Simplify knows most of the information so it would be great if it could keep a print log so we could go back to each one and also print "like this". Each log entry could also have a ...
by CCVirginia
Mon Jul 20, 2015 11:13 am
Forum: Troubleshooting and Bug Reports
Topic: [SOLVED] 3.0 Extruder Temperature resets to 0 Degrees after
Replies: 2
Views: 434

Re: 3.0 Extruder Temperature resets to 0 Degrees after paus

In addition to this, when starting a new print in this condition the Extruder temp is not set so the print never starts. It is necessary to set the extruder temp and then start the print, this should not be required.

Go to advanced search